SYNTHESIS AND CHARACTERIZATION OF MONTMORILLONITE/TiO2 COMPOSITES AS A PHOTOCATALYST IN REDUCING BOD AND COD OF DOMESTIC WASTEWATER
Keywords:
ball milling, sonication, PSA (particle size analyzer), montmorillonite, TiO2.Abstract
The development of hotels in Bali is increasing every year, this is directly proportional to the number of tourists and the waste generated. Hotel liquid waste has the potential to pollute the environment if there is no pre-disposal treatment. This study aims to obtain the best MMT/TiO2 composite that acts as an adsorbent and photocatalytic in reducing BOD (Biological Oxygen Demand) and COD (Chemical Oxygen Demand) levels of domestic wastewater. Composite synthesis was carried out by combining the top-down method, ball milling, and sonication. The ball milling method is used to produce montmorillonite, which has a smaller size, with a ball mass to sample mass ratio of 2:1 at a speed of 250 rpm. Variations in milling times of 0, 2, 4, and 6 hours were applied to determine the effect of milling time. The sonication method was used to obtain a smaller TiO2 particle size by exposing it to ultrasonic waves for 30 minutes. Calsination of the composite was carried out at a temperature of 400 °C. The results of composite characterization using the PSA (Particle Size Analyzer) showed that the composite did not meet the nanoparticle requirements because it had a particle size > 100 nm with a PI value > 0.5, which was still classified as polydispersity. NMT 6 has the best PI value of 0.65, which is then used to determine the optimum composite time to reduce BOD and COD levels. The optimum irradiation time obtained from composites in degrading waste is 90 minutes, which can reduce BOD levels by 78.53% and COD levels by 69%. The ability of composites NMT-6 to reduce BOD and COD levels is greater than that of montmorillonite and TiO2.Downloads
References
Aji, N. R., Wibowo, E. A. P., Ujiningtyas, R., Wirasti, R., dan Widiarti, N. 2016. Sintesis Komposit TiO2-Bentonit dan Aplikasinya untuk Penurunan BOD dan COD Air Embung UNNES. Jurnal Kimia VALENSI: Jurnal Penelitian dan Pengembangan Ilmu Kimia, Vol. 2, No. 2, P-ISSN: 2460-6065, E- ISSN: 2548-3013
Afrozi, A. 2010. Sintesis dan Karakterisasi Katalis Non Komposit Berbasis Titania Untuk Produksi Hidrogen dari Gliserol dan Air.Skripsi. Jakarta: Fakultas Teknik Jurusan Teknik Kimia Universitas Indonesia
Andini, S.A dan Arida, I.N.Y. 2019. Pengolahan Air Limbah Hotel dan Pemanfaatannya dala Pembangunan Pariwisata Berkelanjutan: Studi Kasus Pada Pengolahan Air Limbah Lagon Itdc Nusa Dua. Jurnal Destinasi Pariwisata, Vo. 7, No.2, ISSN: 2338-8811
Atikah. 2017. Efektivitas Bentonit sebagai Adsorben pada Proses Peningkatan Kadar Bioetanol. Distilasi, Vol. 2 No. 2, Hal. 23-32
Badan Lingkungan Hidup Provinsi Bali. 2014. Laporan Pelaksanaan PROPER 2013-2014 di Provinsi Bali. Denpasar
Chen, Daimei., Qian Zhu., Fengsan Zhou., Xutao Deng and Fatang Li. 2012. Synthesis and Photocatalytic Performances of The TiO2 Pillared
Montmorillonite: a article, Elsivier. Journal of Hazardous Materials, 235-236, 186– 193
Fauzi, A.R dan Tuhu, A.R. 2018. Kombinasi Fenton dan Fotokatalis sebagai Alternatif Pengolahan Limbah Batik. Jurnal Envirotek, Vol.10, No. 1
Filliazati, M., Apriani, I., & Zahara, T. A.2013. Pengolahan Limbah Cair Domestik dengan Biofilter Aerob Menggunakan Media Bio ball dan Tanam Kiambang. Pontianak: Program Studi Teknik Lingkungan
Fitriyanti, A.P dan Rahman, A.G. 2017. Pengolahan dan Kualitas Limbah Cair Hotel Swiss-Bell Panakukbang di Kota Makasar Tahun 2017. Celebes Environmetal Sciences Journal, Vol. 1, No. 1, pp 13-20
Geraldina., Taslimah., Rachmad, N. 2016. Pemanfaatan Montmorillonite Terpilar Al-Cr pada Adsorpspi Zat Warna Rhodamin B dengan Variasi Massa Adsorben dan Waktu Adsopsi. Jurnal Kimia Sains dan Aplikasi 19 (39) : 99-106
Khan, A.M., Ataullah., Shaheen, A., Ahmad, I., Malik, F dan Shahid, H.A. 2011. Correlation of COD and BOD of Domestic Wastewater with the Power Output of Bioreactor. Journal Chemical Society Pakistan, 33(2):269-274
Muhriz, M., A. Subagio., dan Pradoyo. 2011. Pembuata Nanopartikel dengan High Energy Milling. Jurnal Sains dan Matematika, 19(1):11-17
Qodri, A.A. (2011). Fotodegradasi Zat Warna Remazol Yellow Fg dengan Fotokatalis Komposit TiO2/SiO2. Skripsi. Surakarta: FMIPA Universitas Sebelas Maret
Rahmalina, D., Rahman, R.A., Suwandi, A., Hananto, G., dan Rillianto, D.A.2020. Pengaruh Penambahan 14-16 wt % NI pada Komposit MG-NI Hail Proses Ball Milling Terhadap Karakteristik Penyerapan Hidrogen. Jurnal Teknologi Universitas Muhammadiyah Jakarta, Vol. 12, No. 2, ISSN: 2085-1669
Sandi, D.K., Baharianto, M.Y., Sani., dan Astuti, D.H. 2021. Pembuatan Komposit Bentonit dengan TiO2 Untuk Menurunkan Kadar COD dan BOD Limbah Cair Ayam Potong. Jurnal ChemPro, Vol. 2 No. 1, Hal 39-43
Saraswati, A. dan Nugraha, I. 2014. Sintesis dan Karakterisasi Montmorillonite-TiO2 dan Aplikasinya untuk Pengolahan Limbah Cair Pabrik Gula. Seminar Nasional Kimia dan Pendidikan Kimia VI. 501, ISBN: 979363174-0
Sedyadi, E dan Huda, K. 2016. Kajian Adsorpsi Remazol Yellow FG Oleh Montmorillonite-Kitosan. Integrated Lab Journal, Vol. 04. No. 02, hal. 139-152
S. Salem, A. Salem, dan A. A. Babaei. 2015. Application of Iranian nano-porous Ca-bentonite for recovery of waste lubricant oil by distillation and adsorption techniques. Journal of Industrial and Engineering Chemistry, volume (23), pp. 154-162
Suarya, P. 2009. Adsorpsi Pengotor Minyak Daun Cengkeh oleh Lempung Teraktivasi Asam. Review Kimia, 2(1), 19-24
Wardhani, S., Bahari, A., Khunur, M. 2017. Aktivitas Fotokatalitik Beads TiO2-N/Zeolit-Kitosan pada Fotodegradasi Metilen Biru (Kajian Pengembanan, Sumber Sinar dan Lama Penyinaran). Journal of Environmental Engineering and Sustainable Technology, vol.3, No.2, pp. 78-84
Downloads
Published
Issue
Section
License
Copyright (c) 2024 Jurnal Ilmu Pendidikan Indonesia
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.
